Faculty Information - Shimoda Takayuki

Shimoda Takayuki

Department / Course FACULTY OF ENGINEERING Department of Aerospace Systems Engineering

Job

Book and thesis
1.	2026/03	Papers	Lectures of the “Best Teaching Award” Winners 2025 ―Idea for Improvement (9th Report)― (Co-authored)
2.	2025/08/31	Papers	Mass Loss Behavior of a Carbon Fiber Reinforced PEEK Resin Composite Exposed to High Enthalpy Flow Environments International Review of Aerospace Engineering (IREASE) 18 (4),pp.138-149 (Co-authored)
3.	2022	Papers	Nonequilibrium Shock Layer in Large-Scale Arc-Heated Wind Tunnel Journal of Physics D: Applied Physics, 55 235205 (Co-authored)
4.	2021	Papers	Flow enthalpy of nonequilibrium plasma in 1 mw arc-heated wind tunnel AIAA Journal 59 (1),pp.263-275 (Co-authored)
5.	2019	Papers	One-dimensional Ablation Analysis of Lightweight CFRP Ablators with Coking Transactions of the Japan Society for Aeronautical and Space Sciences, Aerospace Technology Japan 17:Pe_461-Pe_470, 2019 17 (4),pp.461-470 (Co-authored)
6.	2017	Papers	Experimental Method Using Arc Wind Tunnel to Simulate A New Technique for Communicating with A Reentry Probe Having A Thermal Shield Made of LATS Materials International Journal of Research - GRANTHAALAYAH 5(2):1-12, 2017.02 (Co-authored)
7.	2016	Papers	Empirical Study of the Lightweight Ablator Series for Transfer Vehicle Systems (LATS) Transactions of the Japan Society for Aeronautical and Space Sciences, Aerospace Technology Japan 14(ists30):Pe_41-Pe_47, 2016.07 (Co-authored)
8.	2016	Papers	Evaluation of Artificial Meteor Sources with Arc Heater Wind Tunnel Transactions of the Japan Society for Aeronautical and Space Sciences, Aerospace Technology Japan 14(ists30):Pf_119-Pf_123, 2016.01 14 (30),pp.Pf_119-Pf_123 (Co-authored)
9.	2009	Papers	Verification of JEM Structural Compatibility with the Space Shuttle Tran. JSASS Space Tech. Japan Vol. 7 (2009) No. ists26, pp.Tr_1_5-Tr_1_10, 2009 7 (26),pp.Tr_1_5-Tr_1_10 (Co-authored)
10.	2006/03/23	Papers	Study of Cryogenic Mechanical Strength and Fracture Behavior of Adhesives for CFRP Tanks of Reusable Launch Vehicles Memoirs of the Faculty of Engineering, Kyushu University 66 (1),pp.55-70 (Co-authored)
11.	2004	Papers	Pressurization test on CFRP liner-less tanks at liquefied nitrogen temperature Advanced Composite Materials: The Official Journal of the Japan Society of Composite Materials 13 (2),pp.81-88 (Co-authored)
12.	2004	Papers	A fundamental study of detecting delaminations in composite tanks by using lamb waves Key Engineering Materials 270-273 (III),pp.1898-1904 (Co-authored)
13.	2002	Papers	AE Monitoring of Cryogenic Propellant Tank Journal of Acoustic Emission, Vol. 20, pp. 195-206, 2002 (Co-authored)
14.	2001	Papers	Applicability of CFRP materials to the cryogenic propellant tank for reusable launch vehicle (RLV) Advanced Composite Materials: The Official Journal of the Japan Society of Composite Materials 10 (4),pp.339-347 (Co-authored)
15.	1998	Papers	Flush air data system calibration using numerical simulation Journal of Spacecraft and Rockets 35 (6),pp.812-820 (Co-authored)
16.	1996	Papers	Orbital re-entry experiment vehicle ground and flight dynamic test results comparison Journal of Spacecraft and Rockets 33 (5),pp.635-642 (Co-authored)
17.	1997	Papers	Development of Experimental Vehicle.,pp.627-634 (Co-authored)
18.	1999	Papers	The numerical and experimental simulation of hypervelocity flow around the HYFLEX vehicle forebody Shock Waves 9 (1),pp.57-67 (Co-authored)